Sanitary centrifugal pump is a kind of single suction, single-stage and centrifugal sanitary pump. It is suitable for conveying milk, beverage, wine and other liquids. It is an indispensable transportation equipment in food, chemical and pharmaceutical industries. The maximum temperature of absorption is about 200 ℃. Among them, the high lift pump is especially suitable for pipe sterilization, yogurt temperature holding equipment, CIP cleaning and other systems with high resistance.

Organization characteristics:

This series of pumps are mainly composed of pump body, pump seat and motor. Each part is connected by bolts.

The support foot under the base plate can be adjusted arbitrarily, which is convenient for installation without fixed installation foundation. The outlet pipe can be installed in vertical or horizontal direction according to different needs.

This series of pumps are designed with smooth transition, rigid structure and thick wall design.

In the selection of materials, the pump body, pump cover, impeller and other parts in contact with materials are all made of AISI316 or AISI304 stainless steel.

Mechanical shaft seal is made of high quality stainless steel and silicon carbide. The wear resistance and moistening type are greatly improved, and the service life is prolonged. The motor adopts the internationally famous "ABB" motor with IP55. F class insulation and wide voltage structure.

When making, the pump body and impeller are cast by integral precision casting, and all parts are surface treated.

During installation, the dimension clearance shall be ensured by special fixture.

The shaft seal adopts an open structure, so even if there is a small amount of leakage at the shaft seal, it can be observed in time. Even if it is not detected for a short time, it will not overflow the motor. Thus, the service life of the motor is guaranteed.

This series of pumps are fine, not easy to scale, especially suitable for CIP cleaning.

This series of pumps have the advantages of simple structure, convenient disassembly, low voice, high efficiency, gentle and soft material handling, meeting the requirements of food hygiene and ensuring the original flavor of products.

instructions:

In centrifugal sanitary installation, the position of the pump should be lower than the suction liquid level (if the installation position of the pump is higher than the suction liquid level, tank pump should be carried out before starting the pump). Before use, check whether the rotation direction of impeller is correct;

Whether the nuts of the pump inlet and outlet pipe joints are tightened; the sealing ring between the pump cover and the pump body is well padded. Steam disinfection should be applied before use to ensure food hygiene.

A butterfly valve shall be installed at the outlet of the pump to control the flow. In case of long-term overload, do not damage the motor.

CIP cleaning should be carried out immediately after the pump is used to prevent material adhesion. Manual cleaning is required if CIP is not available. During cleaning, hot water can be used to pass through, and then dismantle. Brush all parts of the pump that contact with materials, and then wash them with water. After cleaning, install them in order.

In use, if there is material dripping on the ground after the pump shell, it indicates that the shaft seal is leaking. At this time, check the mechanical seal device on the shaft. If the wear is severe or the seal is damaged, it should be replaced or ground before use.